xboxscene.org forums
OG Xbox Forums => Modchip Forums => Team Omega Chips (DuoX) => Topic started by: i_albarran on September 26, 2005, 09:14:00 AM
-
hi to everyone, i hope someone could help me with this one
i recently install a duox2 white on 1.6a mobo, it was working ok for about an hour then the xbox went off, then on for 1 min. then off again, when i push the power and eject button nothing happened, after i unpluged the power cable i heard a "fade out" scratch on the tv speaker, if i plug the power back the it turns on by it self for a litle while then the same issue repeats. I wait about an hour to try again and i was able to use the power and eject buttons again, but after 30 mins, the xbox repeat the symptom.
Please help me :(
-
Hi,
It sounds like the culprit may be a weak connection between your modchip and your motherboard. When the motherboard heats up, it expands which would result in poor/loss of connectivity bectween the soldered components. When it cools off, the contacts shrink an re-establish connection.
Check all of your soldered joints to ensure they are properly soldered. Also ensure there isn't any excess flux touching any other components.
-
check your bt connection sounds like you may have caused some damage.
v1perfan - as far as i know m8 , flux aint conductive
so it wouldnt matter if there was flux touching other components , solder yes , but flux no :beer:
This post has been edited by antz1970: Sep 27 2005, 02:32 AM
-
done..
i doble checked the solder on the lpc everything is in order, and i checked other guides for this issue, im thinking that the xyclops is wrong, i know that xyclops has the pic integrated so i will replace it, i already order it, it will be on my place next week.
I hope i can get this mobo working, i will post further advances.
Thanks a lot guys