xboxscene.org forums

OG Xbox Forums => Modchip Forums => Team Omega Chips (DuoX) => Topic started by: hippo on August 13, 2005, 06:01:00 PM

Title: Problems With V1.0 And Duox2 (white) Mod
Post by: hippo on August 13, 2005, 06:01:00 PM

If the led on the chip never goes active check ground, power, or BT. If the LED on the chip is active and you find yourself in MS mode check D0.

Title: Problems With V1.0 And Duox2 (white) Mod
Post by: HackDaBox on August 13, 2005, 08:02:00 PM

Use a multimeter on VOLTS DC. Black probe on pin 2 Ground and Red probe on pin 9 ( 3.3v ). If you dont get close to 3.3 volts then you have a problem !

Follow this Duo X2 Troubleshooter i made ...

Duo X2 Troubleshooter!

HackDaBox !

Title: Problems With V1.0 And Duox2 (white) Mod
Post by: LepPpeR on August 13, 2005, 08:22:00 PM

what about the BT point?  is that soldered correctly?

Title: Problems With V1.0 And Duox2 (white) Mod
Post by: Chancer on August 14, 2005, 07:34:00 AM

You can check if the D0 is correct by simply running it to ground. the box should fRAG as the chip LED is not lit.
The problem would seem to be on the LPC. As stated Pin 9 should have 3V3
Its is likley if you used a pinheader that you did damage to the lPC removing the solder in the holes as its a V1