xboxscene.org forums

OG Xbox Forums => Modchip Forums => EB2K Chips (X-Chip) => Topic started by: tihspeed on December 28, 2005, 11:45:00 PM

Title: Disabline X-lite Chip
Post by: tihspeed on December 28, 2005, 11:45:00 PM

please explain how you are loading the ms bios.  this may help. the light should shut off

If your xbox is a version 1.0 there is a PDF file somewhere i've seen in the past that says you cannot use the eject button to disable your chip you must boot your box holding a button to disable your chip.  If you are aptempting to go onto xbox live with your 1.0 chip you will get banned.  This also was for a x-chip... dunno bout the x-lite i never read those directions.

Title: Disabline X-lite Chip
Post by: rasstar on December 29, 2005, 06:55:00 AM

I boot the MS bios by holding down the X button. The Ms bios loads and I am able to get on Live but I have been banned. The xbox is a 1.4 so I don't understand. The light remains on all the time.

Title: Disabline X-lite Chip
Post by: tihspeed on December 29, 2005, 05:21:00 PM

what happens if you boot using the eject button?  just trying to close all roads

Title: Disabline X-lite Chip
Post by: rasstar on December 29, 2005, 08:07:00 PM

The light still stays on. Even when I boot use the PCB to turn off the chip the light on the chip stays on and two lights on the pcb comes on also.

Title: Disabline X-lite Chip
Post by: tihspeed on December 29, 2005, 10:14:00 PM

weird. what other bios can you use on your chip. Maybe its the bios conflicting with chip. you've exhausted all posibilites.  the only thing left is bios. maybe try a reflash or re download.  it couldn't hurt anything.  other than that I would have to say it would be the chip, but I hate to say that.  Its almost always operator error.  Any x-lites wanna chime in here... man this board is dead since the 360 came out.

Title: Disabline X-lite Chip
Post by: RicZilla on January 03, 2006, 11:27:00 AM

I think the light on the chip PCB is always on even if it's disabled it just show that you have +5 volts going to it.  Do you have the DIP switch header installed ?  Look at the disable led I think it's yellow when it's disabled you can also try the dip switch that disables the modchip see if that works.  I never play on live so havent tried disabling it much only for troubleshooting.

Title: Disabline X-lite Chip
Post by: rasstar on January 03, 2006, 05:42:00 PM

I did everything. I guess the light remains on no matter what. On the PCB a greenish light comes on when i disable it with the PCB.

Title: Disabline X-lite Chip
Post by: RicZilla on January 03, 2006, 08:42:00 PM

From the xlite_settings.pdf

Detachable PCB:

Red means there is power going to the chip.

Green means the chip is in recovery mode (Cromwell flash menu)

Amber/Yellow means the chip has been disabled.

SW#4 has to be ON to see those leds.

SW#1 has to be ON to disable the X-Lite

Hope this clears up things.

I'm at home now and just tried it and that's what it does.

Except mine is stuck in recovery mode