Post by: christineyoung on May 18, 2005, 12:16:00 PM
As well, telephone wire should work, just make sure no wire crosses each other ( aka ontop of each other )
As well if fragging means you have LFRAME connected right, and if LED's means 5V is connected right.
Make sure you also have all pins on pin header soldered as well.
Post by: rasdude on May 20, 2005, 08:19:00 AM
After soldering the other pins in place, it now frags only when I have the X-lite enabled (dip #1 set to "on"), and it boots up to the MS dashboard when it's disabled. This is a change to how it was previously when having the X-lite plugged into the pin header caused it to frag every time, independent of the dip switch settings.
Any more ideas?
Post by: VOIP_71 on May 25, 2005, 12:11:00 PM
