xboxscene.org forums
OG Xbox Forums => Modchip Forums => EB2K Chips (X-Chip) => Topic started by: cravavar3 on August 12, 2004, 12:35:00 PM
-
Are you using the posted 5V wire in diagram ( red one )? If so you woudl be supplying 5V through the secoond pin to another 5V not good.
-
Yes I am using the Red wire in the digram to supply 5v.
on the top of the motherboard, I have a wire to connect the d0 point to the xchip. this is also what i see in the diagram. on the underside of the diagram, i have the same 4 wires connected on the bottom. the only wires that are connected are the same as the easybuy2000 1.6 manual.
i hope this helps. I am not sure where the second5v would be coming from.
Thanks again for any help
-
Do you have both pins removed from header as eb2k method?
If you only have 1 pin remove ( pin #4 ) pin #6 on lpc port supplies 5V's as well and that is why they have 2nd pin removed.
Also, note there D0 wire length is 4 inches or less
-
I have both pins removed.
The first time i tried was before the eb2k guide came out and i used the Xenium guide to rework the lpc port. At that time i did not have the 5v wire on top but i only hadone pin removed. I had the same problem i do now.
Now i have the 5v wire on top and the extra pin removed. I did not ever have both the extra pin and 5v wire connected so i don't think i did any damage.
However i wonder if in using the Xenium guide and having the extra pin in there i did damage to something??
Thanks again for all your help. I really feel i have done everthing right and i know what i am doing(apperantly not though). its just not working and i hope someone can shed new light on the situtation or provide something i did not know or did not try. thanks again for any help. i really appreciate it.
Does anyone know if you have to load the raw full16 file to make the xchip work with xbox 1.6??
-
Also the d0 wire is less than 4 inches long.
-
The extra pin that was there before was old methods of install and cause power to be always on X-Chip or any other modchips. No damage can occur from using it.
Have you tried loading evox 1.0 for 1.6's???? Also you may want to scrap the D0( actual LFRAME ) on xbox and verify connection.
Also verify your XCHIP is pushed all way down and secure and you wire to proper D0 and + 5V ontop of X-Chip.
Also, have you tried with X-Chip out and see if xbox works??????????
I did a install on a 1.6 this monring using the guide and up and running, used Evox 1.0 for 16 ( full16.bin ) file. Only think is I can point out is make sure D0 is only touching the one spot , real tight there and someon coudl actually solder more then 1 spot and not know if they are not good solderer.
-
If you can post your bottom install of 4 points I can look at images.