xboxscene.org forums

OG Xbox Forums => Modchip Forums => EB2K Chips (X-Chip) => Topic started by: jop12 on August 08, 2004, 01:39:00 PM

Title: Need Help, After Installing
Post by: jop12 on August 08, 2004, 01:39:00 PM
I installed the xchip, it was red when i powered up the xbox, I put the xbox back together, power it up again with it hooked up to a tv, and it boots the ms dashboard instead of the cornwell...Can you help me?

ps. One thing i didn't do is scratch the do point slightly with a pen, but should that matter if it still had the red light on when i powered my xbox?

One more thing, the packet came with rivets, and i have a xbox v1.1, so I dont have to use anything in the packet with rivets, except the screw, right?

Thanks.
Title: Need Help, After Installing
Post by: twisted.penguin on August 08, 2004, 03:50:00 PM
You D0 isnt making proper connection, please clean off the d0 point and inster the solderless adapter into it. Also make sure its in the right hole.
Title: Need Help, After Installing
Post by: jop12 on August 09, 2004, 09:13:00 PM
smile.gif
Title: Need Help, After Installing
Post by: cravavr3 on August 09, 2004, 09:38:00 PM
tongue.gif  Hope this will help others with same issues tongue.gif