xboxscene.org forums
OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: mikearama on September 02, 2006, 07:40:00 AM
-
Just got handed a Chameleon chip to install, and I cannot find a working guide or diagram... not here or at xodus. Just a close up of the P/E diodes.
Any help out? Preciate it.
-
No one has any chameleon install pics stored anywhere? Sure could use the P/E points...
Thanks.
-
I don;t have a pic - but this helped me out - real easy to understand.
Alternate Method 1 to attach the Power and Eject lines to the Xbox under the MOBO
Use the pic below as a guide. (NO PIC SORRY) Locate the front panel wiring harness (a connector holding 9 yellow wires). You can see that Pin 1 is indicated by a small triangle on the motherboard.(top of the MOBO) Using Pin 1 as a reference point, Pin 2 (Power button line) is opposite Pin 1. Pin 4 (Eject button line) is next to Pin 2 (diagonal from Pin 1). NO FLIP IT OVER and SOlder to those pins.
Easy enough.