xboxscene.org forums
OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: akillamuthafucca on July 21, 2004, 06:43:00 PM
-
use software control add the lines to the ini file and disable the modchip by switching to tsop
-
If you can't solder then stay away from those points the are very small & easily damaged.
Since you have the solderless adapter I would recomend sniping the D0 pin (the one connected to that little bit of wire sticking out of the adapter)
Buy a toggle switch (http://www.maplin.co...ages/2340i0.jpg) just like the one on the left.
solder a piece of wire from one side of the switch to the pin that you sniped & another piece of wire from the other side of the switch to the D0 point on your cham chip.
flip the switch one way & the chip is disabled flip it the other way & it's enabled.
there are lots of ways you can mount your switch on your xbox I'll let you decide which way to choose.
-
Hey here is what I do. I flashed my xbox to not load the game by default.
I then added these lines to run my games.
Oh yea I removed the xbox dash setting and changed it to this also
MSDashBoard = "d:\default.xbe"
And here is how I launch games
[Menu]
Section "Root"
{
Line "**********************************"
Line "Choos a way to Launch a Game"
Item ">>Non Xbox Live enabled Game<<",ID_MS_Dash
Line "or Insert Live Enabled Game and..."
Item ">>Launch<<",ID_Chameleon_Release_D0,ID_Full_Reboot
Line "**********************************"
You can word it how ever you want to but this should and does work really good.