xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: Infamous on February 06, 2004, 11:57:00 AM

Title: Chameleon And Xbox 1.5 Problem
Post by: Infamous on February 06, 2004, 11:57:00 AM

forgot to mention, this is my first time working with the 1.5 xbox.

Title: Chameleon And Xbox 1.5 Problem
Post by: ofx210p on February 06, 2004, 12:35:00 PM

Have you made the wiring modifications to the xbox before installing the pinheader  ?

If you need help email me

Cheers

Chris

Title: Chameleon And Xbox 1.5 Problem
Post by: oo7texas on February 06, 2004, 09:09:00 PM

same problem here...i just installed a chameleon on a 1.2 and i had absolutely no problems but i tried putting one in a 1.5 and i get the factory settings and bios...no cromwell screen. can someone email me the wire modifications as well. thanx.

Title: Chameleon And Xbox 1.5 Problem
Post by: ytsejam on February 07, 2004, 04:14:00 AM

On a 1.5 Xbox you need to do the following:

Xbox 1.5 Wire diagram

You don't need the 3.3V wire just the ground

Title: Chameleon And Xbox 1.5 Problem
Post by: Infamous on February 07, 2004, 10:18:00 AM

yea i would like to know that same question as well, and also, are you sure that i only need to do the ground wire?

Title: Chameleon And Xbox 1.5 Problem
Post by: ytsejam on February 07, 2004, 03:21:00 PM

Yes you can solder it to the pogo pin and I am sure you only need the ground wire.

Title: Chameleon And Xbox 1.5 Problem
Post by: ofx210p on February 09, 2004, 02:57:00 AM

The solderless adaptor also comes with a set of small rivets that you push into the holes to make a better contact If you havent any PM me.

You shouldnt be using the solderless adaptor without them on the non filled lpc versions of the motherboard.