xboxscene.org forums
OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: diseaser on November 02, 2003, 11:00:00 AM
-
Anyone?
-
Hmmm. Try this for argument. Try flashing Bank 0 and 1 with Cromwell. If it works you can re-flash using M7 or 4977.
JD
-
Would that have anything to do with bank 0 not working?
Any other suggestions?
Thanks in advance,
diseaser
-
Damn.
-
Good luck
-

So you had the same "power on/off resulting in red/green fragging" problem too?
Can other banks work if LPC pin2 is not making contact? I ask becasue I know banks 2 and 3 work fine, so I just assumed that LPC pin2 was definitely making contact.
I will give this a try and holler back.
Thx,
diseaser
-
Well, no luck.
Xbox 1.0
Chameleon Solderless
Some info:
-- Banks 2/3 work fine. They display the cromwell bios boot screen (Waiting for CD) and appear to be functioning normal (flashing appears to work).
-- The chip appears to be seated properly. I have scraped etches into the solder w/an exacto knife, and banks 2/3 work fine, so I assume all the connections are being made.
-- I have tried reflashing bank 0 with cromwell, evox M7, x2 4977 (256k), x2 4978 (512k), none work.
-- This began when I flashed a 512k x2 (4978 I believe) onto the chip.
Is it possible banks 0/1 are fried? I don't suppose Xodus or EasyBuy has a warranty? Somehow I doubt it. :
Again, when I use bank 0 to boot, the power goes off/on 2 times, then comes on with a red/green eject light. I don't think it's "working" because the power isn't on even remotely long enough to spin up the dvdr and boot something before it turns back off. I think the chip is seated, because banks 2/3 appear to work fine.
Anyone else have anything for me to go on?
Trying not to waste $50,
diseaser
-
Ok. Let's try something. You say you flash a 512k BIOS first and that is when everything started. This is the second time in a week I have seen the problem. I doubt you messed up anything. I am just wondering if you screw up bank 1 would this have any bearing on bank 0 not booting or flashing correctly.
The programmer may work to solve this, but I am still trying to figure out why there would be a problem. Let me see what I can dig up for you today.
JD
-
Jon and all else,
I fixed it!
Here is what i did:
I took Evox M7 and opened it in XBtool.
I didnt change anything except making it into a 512k bios instead of 256k.
I flashed it, it booted in bank0 on the first try!!
I hope this helps ppl that experience this in the future.
Jon, Parabolee: Thank you so much for your help and troubleshooting.
Let me know if I can ever be of assistance. My email is [email protected].
Thanks,
diseaser
PS: WOOOOOOOHOOOOOOOOO!!!!
-
Now just for my peace of mind, tell me the position of the dip switches on your chameleon.
JD
-
As of this moment (everything working great) they are all off (default).
I also saw someone in #evolutionx on efnet with the same problem and I gave him my solution and it worked.
Just FYI.
Thanks again,
diseaser
-
But you say you flashed with a 512k BIOS yes? This is definately interesting.
JD