Post by: TEAM XODUS on September 04, 2003, 03:39:00 AM
regards
Xodus
Post by: TEAM XODUS on September 04, 2003, 04:33:00 AM
.. what u can do is use the solder pads ment for the direct solder solution
Or better yet simply fill in the holes of the LPC points .. clean them well and try the solderless addaptor .. that should work okay if the holes are filled in ( thats all the rivets do )
keep us informed
Xodus
Post by: Xeero on September 04, 2003, 04:49:00 AM
| QUOTE (SKS @ Sep 4 2003, 08:40 AM) |
| *Just had a thought. Im going to stick the pin block adapter into the chameleon an use computer led wires....the ones that go nicely onto those pins. Ill solder those on the other end and it should work.... |
Why not just use the existing pin header? It will be a much cleaner fit with the female pin header on the chameleon.
Post by: TEAM XODUS on September 04, 2003, 04:52:00 AM
R u sure the chip it`s self is okay ? If u do use wires install .. try and keep the wires short ..
let us know
Xodus
Post by: mirx999 on September 04, 2003, 01:35:00 PM
). check that the xbox boots with nothing installed.
Post by: Dankbud on September 10, 2003, 10:34:00 AM
| QUOTE (SKS @ Sep 4 2003, 09:11 PM) |
Well I hate to give up, but this is not getting me anywhere. Im going to buy another console and Ill wait for some rivets. I dont understand why the solderless wont work with the LPC holes filled wiith solder.... either way.. I refuse to let this beat me so I will keep at it. D0 point was checked and rechecked....scratched prodded poked and cleaned...  |
must be nice to just go out an buy another box cause u cant get the chip to work rght....u can donate ur old one to poor ass me
Post by: SKS on September 10, 2003, 06:28:00 PM
Post by: feflicker on September 10, 2003, 06:55:00 PM
Post by: mirx999 on September 11, 2003, 11:42:00 AM
| QUOTE (SKS @ Sep 10 2003, 10:28 PM) |
| Happy to say that I got the chip working perfectly in my orgininal xbox. I was busy looking for an alignment LED to come on, when there isnt one..... idoit....lol |
