Post by: WodMan on August 04, 2003, 03:10:00 PM
Post by: dzv on August 05, 2003, 04:49:00 AM
Secondly, check that he hasn't broken off a capacitor or some other component near the LPC bus. Check the following tutorial for details of the capacitor I mean:
http://www.xbox-scen...c-capacitor.php
Post by: Kad on August 05, 2003, 04:55:00 AM
Post by: cityson on August 05, 2003, 06:35:00 AM
| QUOTE (Kad @ Aug 5 2003, 01:55 PM) |
| nothing seems to be broken : i've his xbox here also and now i've also tried to fit an Xectuter 2.2 pro, and nothing, the problem persists. any sugestions ? |
Is it "your" Xbox?
Post by: stodge64 on August 05, 2003, 06:41:00 AM
sorry m8 couldent help it.
Post by: WodMan on August 05, 2003, 06:43:00 AM
| QUOTE |
| no video, nothing, the xbox just "hangs" after the reboots, no ejectvideoetc |
I have seen this a few times and 90% of the time it is a solder splash or broken trace. (I would say in your case it would be a damaged d0 from the alignment process)
5% of the time it is some sort of component (diode, capacitor, etc) has been lifted off of the board.
The other 5% of the time it seems that somehow during or after the mod a component on the board goes bad, perhaps from a static shock or other anomoly. These are destined for the xbox graveyard in the sky.
Post by: WodMan on August 05, 2003, 07:38:00 AM
| QUOTE |
| Hi I have the same problem with a friends xbox but with the modchip out or turned off the xbox works fine. Would this be a D0 problem and if it is how can this be solved? |
If the Xbox works fine with the mod disabled and FRAG's with the mod enabled, then you know that you have a good d0 connection. Your problem either lies in the LPC connections, the DIP settings, or the bios on the chip.
Post by: Kad on August 05, 2003, 04:07:00 PM
D0 is ok... traces ok...
i think i'm gonna have to give him the bad news : xbox caput =(