xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: xero2k on June 23, 2003, 03:35:00 PM

Title: Matrix Install After Flashing Bios To Evox2.6
Post by: xero2k on June 23, 2003, 03:35:00 PM
So Im putting my chip back in and I allign it all up and it turns green... I switch it back to mode 2 and start the Xbox again, it does the reset thing...So I check it, turns out the top pogo was alligned over the TOP hole (the 2 holes that are close together, the bottom one is the right one...) So anyways I get it on the RIGHT spot for sure (I ghetto rigged it, theres a needle instead of a pogo pin so it goes into the hole) anyways so its still red, I tried it anyways and its in mode 2 and the light is green but the xbox loads normal, wtF??