xboxscene.org forums
OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: laxton316 on June 04, 2003, 08:43:00 AM
-
Hey gang,
Been playing with the matrix I got a while back. I have successfully used it to flash a couple V1.0 xbox's and now something strange has happened. When I connect the matrix and the programmer together and install on my laptops printer port now, it flashes red as it's supposed too then it kind fades out. I can just barely make contact with the printer port and it stays lit up, but if pushing it all the way in to were it's properly seated, it goes out again.
I just put in a new 9 volt battery so I wouldn't think that's the issue, but I may be wrong. I haven't had time to pick up another one yet. Whatcha's think? Crashed my chip or programmer or just the battery? I was wondering if anyone else had an issue like this happen.
Thanks in advance!