xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: JapanFred on May 23, 2003, 01:37:00 PM

Title: Xbox1.1 Matrix...alignment...
Post by: JapanFred on May 23, 2003, 01:37:00 PM

hey, my MAtrix wont align, i've tried many times, it either boots the normal Green flubber Bios, or it doesnt boot, it just turns on off etc.

So, Should i solder the holes up, as i heard this is a better solution?


Thanks.

Title: Xbox1.1 Matrix...alignment...
Post by: rickyd on May 23, 2003, 01:43:00 PM

If you can solder than go for it.  If you wanted to try to get it to work without soldering you can keep trying to align the pins but the key is to make sure that the LPC Pogo pins of the chip do not go into the LPC holes.  Remember too that when testing in mode 1, when you first turn on the Xbox the light will flash green for a second then flash red.  Good luck.