xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: blackout_19 on December 16, 2002, 09:45:00 AM

Title: Matrix Modchip Beeps
Post by: blackout_19 on December 16, 2002, 09:45:00 AM

Sounds like alignment or a bad flash. This happens if you have an iffy solder point on a cheapmod as well.

Best to reflash AND re check the alignment. make sure you get green in all modes to check alignment.

Title: Matrix Modchip Beeps
Post by: kkattfish on December 16, 2002, 09:53:00 AM

Title: Matrix Modchip Beeps
Post by: cRaCKwHoRe on December 16, 2002, 10:14:00 AM

I noticed that I had to pinch and wiggle the Matrix on the programmer too. What a cheap device LOL... If it wasn't in a certain position, WinLPC would return an error to me.

Title: Matrix Modchip Beeps
Post by: bluefear on December 16, 2002, 10:52:00 AM

QUOTE (cRaCKwHoRe @ Dec 16 2002, 06:13 PM)

Thanks for the replies folks. Blufear ->> your guide is awesome... I'm at work now. Can't wait to try it out when I get home.. When you say insulation tape, you talking about that black electrical tape? If not, is that ok?

                                    Yes, I used normal black insulation tape.   I cut two small strips and stuck it either side of the g-spot trace.

Good luck,
bluefear

Title: Matrix Modchip Beeps
Post by: cRaCKwHoRe on December 16, 2002, 11:54:00 AM

Thanks! Just got Slayer's Auto-Installer too. Hope that will ease my boot problem too once I get the chip aligned.

Title: Matrix Modchip Beeps
Post by: frekkle on December 16, 2002, 12:19:00 PM

for best results use Evox D.6 (just in case your box is not a v1.1)

Title: Matrix Modchip Beeps
Post by: frekkle on December 16, 2002, 12:26:00 PM

for best resluts clean the LPC points before you install it (with alcohol)

Title: Matrix Modchip Beeps
Post by: cRaCKwHoRe on December 17, 2002, 09:42:00 AM