xboxscene.org forums

OG Xbox Forums => Modchip Forums => Matrix & Chameleon Modchips => Topic started by: knowledgeiv on December 16, 2002, 07:22:00 AM

Title: Guide To Successful Matrix Install On A V1.1
Post by: knowledgeiv on December 16, 2002, 07:22:00 AM
beerchug.gif

This seems like an excellent method for all those v1.1 users out there.  Since I have only seem v1.0 so far, I have a hard time helping those with v1.1.

And if you don't mind, I would like to post it on my Matrix Tutorial Site to help others out; let me know if this is OK with you.
Title: Guide To Successful Matrix Install On A V1.1
Post by: jabthehut on December 16, 2002, 11:25:00 AM
smile.gif
Title: Guide To Successful Matrix Install On A V1.1
Post by: energyBB on December 16, 2002, 12:42:00 PM
PROPS il try ur tips right away
i so hope this wil work
Title: Guide To Successful Matrix Install On A V1.1
Post by: Knuck3ls on December 16, 2002, 01:10:00 PM
I found that using a needle (not the sharp end) to test alignment worked very well, even on my v1.0 Xbox
Title: Guide To Successful Matrix Install On A V1.1
Post by: Knuck3ls on December 16, 2002, 03:14:00 PM
Well, the 3 holes around the top most pogo pin, I will put the blunt side of the needle into, on each one with the Xbox powered off, and make it so its a snug fit, tighten matrix down, power on, Green!

Works everytime for me...
Title: Guide To Successful Matrix Install On A V1.1
Post by: knowledgeiv on December 16, 2002, 03:17:00 PM
smile.gif