xboxscene.org forums

OG Xbox Forums => Modchip Forums => All other Alternative Modchips and Cheapmods => Topic started by: Chamrock on November 01, 2002, 12:45:00 PM

Title: Homebrew Chip Problems
Post by: Chamrock on November 01, 2002, 12:45:00 PM

I was unlucky pulling the wire to solder point 27 when I was trying to loose it by heating the solder. Then I also pulled the solder point. Since this happened I have tried to run the Xbox in normal mode and it works. Do you know if I can go for another of the thre closest points? If I remember correctly I think some of them link to 27. Will the Xbox be disfunctional because this point cannot lead to the point at the front of the mobo? I am refering to the homebrew guide here at Xbox Scene. If you don´t know what I am saying I would be really happy if you could talk to me at ICQ 39059075

                                   

Title: Homebrew Chip Problems
Post by: opjose on November 01, 2002, 01:19:00 PM

See my sig.

Try to see where the next "pads" are on either side of the break.

Also remember that you may have nuked a feed thru, so you'll need to find the pad on the other side of the board as well.