Post by: opjose on May 17, 2004, 01:12:00 AM
Have you switched it to NTSC or is this available in a menu?
Assuming that you are not exceeding the capabilities of the projector, "ringing" (you used the correct term), usually results from the signal being reflected back from the end of a cable.
In turn this tends to indicate improper TERMINATION or IMPEDANCE mismatch between the two devices.
Post by: blingbling on May 17, 2004, 07:58:00 AM
Post by: Mr Ed on May 17, 2004, 09:43:00 AM
Have you disconnected all other input sources/cables to the device at the same time to see if that makes a difference (this is similar to opjose suggestions who pointed to impedance or termination issues)?
Post by: daves25 on May 17, 2004, 03:47:00 PM
| QUOTE (Mr Ed @ May 17 2004, 06:43 PM) |
| Have you tried just using the cables that came with your MS A/V pack? Are you cables unusually long? Have you disconnected all other input sources/cables to the device at the same time to see if that makes a difference (this is similar to opjose suggestions who pointed to impedance or termination issues)? |
The pack i'm using isn't an MS pack and didn't come with cables. The component cables i'm using are 1.8m in length.
All other input cables are disconnected.
Thank you.
Post by: opjose on May 17, 2004, 04:51:00 PM
| QUOTE (Mr Ed @ May 17 2004, 05:43 PM) |
| Have you disconnected all other input sources/cables to the device at the same time to see if that makes a difference (this is similar to opjose suggestions who pointed to impedance or termination issues)? |
Yeah, good point!
Post by: Mr Ed on May 17, 2004, 05:56:00 PM
Post by: blingbling on May 18, 2004, 07:13:00 AM