Post by: themenace on July 10, 2002, 05:10:00 AM
I've read SniperKilla's tutorial about flashing the xbox bios to evo2.2 but he mentions that you would need switches....as I don't know where to get these here in my location is it possible just to cut the 2 wires of the xtender chip when you normally would put the switches open according to SniperKilla?
If the flash is succesfull you wouldn't need the xtender chip anymore, right?
-->
If your chip was a ST chip, make a c:\roms on your xbox and put the evo2.2 bios in it found on the evolution x release.
Then load up the evolution x dashboard, go to system utilities, then flash bios.
Open both switches off position *** or cut the wires???***
Then open your ftp program, browse to c:\roms, then execute :
flashbios name.bin
Replacing name with whatever your bin name is.
There should now be a bar on your tv showing the progress of flashing.
It will tell you its rebooting, leave the mod switches open, if the evolution x dashboard loads, it was successful, try booting a backup.
You can then remove the mod or leave the switches open.
Post by: fedepctv on July 10, 2002, 07:41:00 AM
Thanks
Post by: themenace on July 10, 2002, 09:29:00 AM
See the tutorial:
Flashing the xbox tsop
Post by: gggie on July 10, 2002, 01:08:00 PM
)this switch installation thing sounds safer than cutting wires while the xbox is on -- but, heck, i don't even know what a switch looks like never mind how to install one... (is it terribly difficult?)