xboxscene.org forums

OG Xbox Forums => Hardware Forums => General Hardware/Technical Chat => Topic started by: merlin008 on February 28, 2008, 07:58:00 AM

Title: No Error Code! Help!
Post by: merlin008 on February 28, 2008, 07:58:00 AM

I have a v1.0 and flashed the tsop. Everything was fine... went to florida for a five day vacation and got back plugged it in and now it boots to the call customer service screen with no error code. It loads the x2 bios and then THE SCREEN! anyone got and advice????????   thanks

Title: No Error Code! Help!
Post by: 1hotjob on February 28, 2008, 09:45:00 AM

Can you boot Slayer's or a game disk?

Title: No Error Code! Help!
Post by: merlin008 on February 28, 2008, 10:13:00 AM

no game disc no AID, now it seems to not even get to the bios and go directly to that screen>

Title: No Error Code! Help!
Post by: lordvader129 on February 28, 2008, 12:04:00 PM

are you sure its loading the x2 bios? that should have an error code

the stock 1.0 bios doesnt though, did you have you TSOP split at all?

Title: No Error Code! Help!
Post by: merlin008 on February 29, 2008, 09:55:00 PM

it goes flubber then no code error screen... no split...

Title: No Error Code! Help!
Post by: Bomb Bloke on March 01, 2008, 05:59:00 AM

Open the console up, check the IDE cable.

If replugging that has no effect, unplug the DVD drive and see if that makes a difference.

Title: No Error Code! Help!
Post by: merlin008 on March 01, 2008, 12:40:00 PM

checked my tsop solder points and found that C7D2 is not there and no where to be found..... YIKES   can i just bridge the two points???