xboxscene.org forums

Off Topic Forums => Other Platforms => Wii (Nintendo) => Topic started by: bigjay8510 on August 05, 2008, 12:33:00 PM

Title: Wiikey Pin 6
Post by: bigjay8510 on August 05, 2008, 12:33:00 PM

I finished all the other points, but I messed up pin 6 is there an alternate point for pin 6?

Title: Wiikey Pin 6
Post by: bigjay8510 on August 06, 2008, 10:20:00 AM

does this right? i wasn't sure if this was it because these are different solder points

Title: Wiikey Pin 6
Post by: bigjay8510 on August 06, 2008, 06:51:00 PM

the different solder points that i use where the ones according to this guide...

http://www.ps2cover....nstallation.pdf

what happened was i got sloppy when soldering pin 6 and basically there is no solder left on pin 6 (not on the wiikey on the board).  so can i just run pin 6 from the wiikey to leg 8 on the ic chip?

Title: Wiikey Pin 6
Post by: bigjay8510 on August 06, 2008, 10:42:00 PM

i wired to the ic chip (pinout 8) when i turn on the wii everything is fine, but the dvd drive is not spinning up.  i have checked al the connections...

Title: Wiikey Pin 6
Post by: bigjay8510 on August 25, 2008, 01:27:00 PM

I connected pin six to the 8th leg with some small wire and its working like a champ.

Title: Wiikey Pin 6
Post by: DimitroffVodka on September 05, 2008, 05:18:00 PM

So Happy I came upon this thread. I did the same thing but on point 3. What guage wire did you use to solder on the IC chip?

Title: Wiikey Pin 6
Post by: swampy1111 on September 06, 2008, 09:12:00 AM

use 30swg kaynar