xboxscene.org forums

OG Xbox Forums => Hardware Forums => General Hardware/Technical Chat => Topic started by: xmod4u on September 21, 2007, 05:45:00 PM

Title: Power Problem
Post by: xmod4u on September 21, 2007, 05:45:00 PM
QUOTE
The most common problems are bad solder connections to the LPC usually caused by a soldering iron with too low a wattage, or damage to the BT point resistor, which results in the Xbox powering on as soon as the plug is put into the wall. The resistor will need replacing with another 10k OHM resistor if this happens.


hope it helps
Title: Power Problem
Post by: anupat3l on September 22, 2007, 09:33:00 AM
QUOTE(xmod4u @ Sep 22 2007, 01:21 AM) View Post

hope it helps


But i didnt solder anything sad.gif
Title: Power Problem
Post by: anupat3l on September 30, 2007, 02:47:00 PM
Anyone else got any suggestions, Ive completely tooken the xbox apart.. leaving only the case. and theirs still nothing sad.gif
Title: Power Problem
Post by: Bomb Bloke on September 30, 2007, 06:43:00 PM
QUOTE(anupat3l @ Sep 23 2007, 02:09 AM) View Post
But i didnt solder anything sad.gif

Nevertheless, something's broken in there.  wink.gif  What dashboards and softmods you've setup on the hard drive make no difference to this matter.

If you unplug the front panel from the motherboard, does it still act the same way?
Title: Power Problem
Post by: DarkMatter on October 03, 2007, 06:48:00 AM
Check the following, as you may have corrosion problems:
http://forums.llamma...pic.php?t=12329
Please let us know if that is your problem.
Regards,
DarkMatter