xboxscene.org forums

Xbox360 Forums => Xbox360 Hardware Forums => Xbox360 General / Hardware Chat => Topic started by: TheGlow on September 25, 2011, 03:53:00 PM

Title: How To Make Pogo Mo Thoin, Non Cap Probe?
Post by: TheGlow on September 25, 2011, 03:53:00 PM

I remember when PMT was first discovered there was all this talk of capacitors and what not.
I said screw it and still used the MRA hack as I've already gotten familiar with it.

Now the dust has cleared and wondering what DIY probes we can use?
I already have a toggle on/off switch for the 3.3v line.
I already made a bootleg probe with 2 needles and resistors for an MRA variant I stopped doing.
So already have a board with a needle soldered on, etc. Not sure what lines that should go to.

Title: How To Make Pogo Mo Thoin, Non Cap Probe?
Post by: iateshaggy on September 25, 2011, 06:53:00 PM

the 20 ohm probe of the mra probe works, so does an old r707 probe.  also a simple ground probe works, this hack isn't very picky.