xboxscene.org forums
Xbox360 Forums => Xbox360 Hardware Forums => Xbox360 General / Hardware Chat => Topic started by: Repoman 108 on September 21, 2011, 06:42:00 AM
-
Hey everyone, I wasn't sure where to post this issue, and here seemed like a better place than any. I've got a Reset Glitch Hacked Xbox 360 Slim which WAS working 100% using an original Xilinx CoolRunner-II programmed correctly and using Nand-X installed using the pin headers in the right places. It was perfectly working, booted XeLL perfectly, but now I've run into a major issue. I figured since we're still waiting for a modified kernel for it, I would just flash a retail image to my slim and play online with it for a while, which worked for a day, but when I decided to flash the ECC image back to it, my Nand-X threw up a bunch of error messages during the writing. Obviously, this WAS NOT good, and so now not only does my Slim not boot (expected) but my Nand-X won't recognise the Xbox as a device, telling me "Device not found". Yes I know, I thought this was a problem with a broken Nand-X too, but i've since made multiple nand dumps of my Falcon JTAG using the exact same setup and it works perfectly. I always get "No Device Found" in Exploit 360 and "No Flash Controller detected" in Nandpro 2.0e. I've since tried removing the CoolRunner to see if it was somehow shorting somewhere, to no avail. I'm running out of ideas guys, any help?
I should add that if I try to boot, it sits at green for a while then goes red and gives me a secondary error of 0022.
This post has been edited by Repoman 108: Sep 21 2011, 02:02 PM
-
sounds like you corrupted the NAND
dont know if the shorting trick works on slims...
-
I've heard of that before, but It doesn't look easy to get right. Can you run me through what I'd need to do to get that working?