xboxscene.org forums

Xbox360 Forums => Xbox360 Hardware Forums => Xbox360 General / Hardware Chat => Topic started by: dailan123 on March 16, 2010, 08:44:00 PM

Title: Helllp With Gpu Overheating (0012)
Post by: dailan123 on March 16, 2010, 08:44:00 PM

i was uncrippling my xbox and and i soldered the 7 wires withe the resistors and the diod
but the flash config in the NandPro wasnt as the correct one as mine was (00023010)

any way i dumped to 0095 (the num was counting in the programe) ,and thedump was about 16 KB
and i closed the NandPro and get every thing back and i left the wires and turned on the xbox

but there was 2 red lights

i got back to the xbox and removed the wires and filled the joints and removed any soldring iron was on the mobo but i did that from the top not from the bottom and i checked the joints i found

the J1D2.7 was grounded likeJ1D2.6

is that right??????
and J2B1.12 is grounded

and there is somthing strange when i check the shorts between GND and the joint in J2B1

i find when i put the multimeter on J2B1.7
it gives a small and short time buzz but very short and almost can be heard

and the same when i put on J2B1.8

and also i noticed a small tilt in the CAP C1D7
the one above J1D2

is this normal also???


any way i put the xbox togther again and after removing the wires i turned on and the sam 2 redlights

i checked the secondary error code and was 0012 (GPU over heating)

what the f*** did the soldring do for this piece of ****???

i really dun know what to do ??

is this for my wrong nand dumping?


or when i removed the mobo to solder i did somthing wrong in putting the mobo back?

or what??plzzzzzzzzz help me

take into ur considration my xbox is jasper 16 MB

any help will be appreciated