xboxscene.org forums
Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: evertonman67 on May 09, 2012, 02:49:00 PM
-
Hi guys,just picked up an Elite 360 with the Lite-on 7 series dvd drive in it.It's a stock/virgin drive as all security seals on the console and the drive are untouched.The console's dash is on the very latest one so i know the drive has been written to with the latest dash update as it showed in J/F as 0251.
I connected the drive to my computer using my trusty CK3 lite and Probe v3,went to extract the dummy.bin and got Phat key extraction failed message,so i turned the drive off then back on again but now my computer can't detect the Lite-on drive what so ever,even in my computers BIOS,it's not listed anymore.
I've tried everything i could think of apart from clicking on Lite-On Erase to try and get it into Vendor mode.As i don't have the key for this drive as yet,i've tried intro/Device ID and the Phat Key buttons and i'm using the latest jungleflasher 1.92.
The drive was there in Jungleflasher BEFORE i got the Phat Key Extraction Failed error but now it's like the drive is dead.I can't open and close the drives tray at all,when i put it back into the console,the console boots up but the centre green light just keeps blinking away and the consoles eject button wont even open the tray.
I know my flashing kit is ok as i can read and flash BenQ's and Hitachi's and i've done Lite-On's in the past.
-
power cycle the drive a couple of times. do not erase it until u have the key.
phat key, switch #6 off, probe mxp01, switch #6 on, hit ok
switch #6 off, unprobe, switch #6 on, ok
-
Thanks so much,shaggy :)