xboxscene.org forums
Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: Dark Mod on October 16, 2011, 03:32:00 PM
-
oki...well is over 90 0225 drive's i've modded so far with the soldering iron technique....but this one is a stumper.
it unlock the drive with no problems when suddenly, terror strikes....drive refuse to be read the OFW and when its about to write, it stuck on bank 0 with just one dot and freezes the PC.
When I reboot and launch JF, same issue.
What can be done to get all banks to read and written?
Or do I have to replace it once more with a 1335 with external SPI
-
i read somewhere that someone put conductive pen into the hole, and that it let the drive go through the flash.
one of the slim 0401 drives i done recently, i drilled 1mm off and hit the wrong bonding wire, taking out the drive eject and drive motor.
the drive could still be flashed, but just wouldnt read the games.
did the eject fix no issues, but couldnt get the drive motor to work again.
point is, even if you drill incorrectly, you should still be able to flash the drive, in my experience.
-
while I was going through the log, I realised my spi status is 0x3c.....that's not good right?