xboxscene.org forums
Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: yeniceirl on October 05, 2011, 12:44:00 PM
-
Hi
I decided to upgrade my Winbond 0225. Having the firmware ready and with the reader in a state 72, I do click WRITE, first erase OK, but at the time of writing gives an error (failure), I reset the console and see that the center LED is blinking, now when I put the reader in a state 72, shows me a window "status 8C ... S / W Protected ...".
I load the UnlockSPI, after the first question "Do you want to continue unloking y/n?" I answer "y" and says "Unknown SPI Flash, Can not go on" and does nothing else. I compare the first line shows me unlockSPI with a Tuto, and see a difference, in the tuto says: SPI device ID = EF 30 12 Winbond, and mine says: SPI device ID = FF FF FF.
How I can unlock my reader and then try to write again, if have the flash erased and write protected?
Please....