xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: peterson99 on February 02, 2020, 05:07:00 PM

Title: Lite On 93450c Boxxdr
Post by: peterson99 on February 02, 2020, 05:07:00 PM: Ok, so i have soldered the wires, 22 ohm resistor, and switch to the board using a DPDT switch. However when i plug the the drives power in (using the ck3 lite), nothing happens, and the red light on the ck3 disappears. Just wondering if anybody know why this happens?
Title: Lite On 93450c Boxxdr
Post by: iateshaggy on February 02, 2020, 05:13:00 PM: because you got solder all over your board.
Title: Lite On 93450c Boxxdr
Post by: Takashi on February 02, 2020, 05:14:00 PM: Pictures help, otherwise we're flying blind
Title: Lite On 93450c Boxxdr
Post by: peterson99 on February 02, 2020, 05:54:00 PM: how do you upload a picture thats on your computer, onto one of these posts? i apologize but i cant figure out how
Title: Lite On 93450c Boxxdr
Post by: Takashi on February 02, 2020, 07:09:00 PM: photobucket preferably
Title: Lite On 93450c Boxxdr
Post by: peterson99 on February 03, 2020, 04:32:00 PM: http://s1095.photobucket.com/albums/i467/p...¤t=100_1428.jpg
http://s1095.photobucket.com/albums/i467/p...¤t=100_1427.jpg

Sorry if the pictures aren't the best my camera kinda sucks.
Title: Lite On 93450c Boxxdr
Post by: Takashi on February 03, 2020, 04:34:00 PM: Bad angle, but still, I can see 3-4 possible areas that would short easily, way too much solder used.
Also, the wire gauge is just too big.
Edited Pic

This post has been edited by Takashi: Today, 12:40 AM
Title: Lite On 93450c Boxxdr
Post by: peterson99 on February 03, 2020, 05:23:00 PM: what wire gauge would you recommend me using?
Title: Lite On 93450c Boxxdr
Post by: Takashi on February 03, 2020, 05:28:00 PM: 30 gauge Kynar works well

This post has been edited by Takashi: Today, 01:28 AM