xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: jadedinc on February 02, 2020, 04:13:00 PM

Title: Order Flash Or Dash? And Orig Key Question.
Post by: jadedinc on February 02, 2020, 04:13:00 PM

I am sure this was gone over before, but I have yet to find the exact answer.

I have a benq with 1.2lt. Should do the USB dash update from m$ to the current dash before or after flashing to new lt+?

Do I have to use the original bin? As I have not done a good job of naming and not sure which is the original for my drive. If I do have to use original, is there a way to read the bins to tell which one would be the original one?


Thanks again for all your guys help and dedication.

Title: Order Flash Or Dash? And Orig Key Question.
Post by: iateshaggy on February 02, 2020, 05:06:00 PM

doesn't matter.

Title: Order Flash Or Dash? And Orig Key Question.
Post by: jadedinc on February 02, 2020, 06:20:00 PM

Doesn't matter with original bin or order of dash/flash , or doesn't matter for either?

Thanks again

Title: Order Flash Or Dash? And Orig Key Question.
Post by: crackalac on February 02, 2020, 07:14:00 PM

QUOTE(jadedinc @ Nov 28 2010, 07:20 PM)

Doesn't matter with original bin or order of dash/flash , or doesn't matter for either?

Thanks again

both dont matter assuming the bin you are talking about is for the correct drive as the drive-key must match.

Title: Order Flash Or Dash? And Orig Key Question.
Post by: iateshaggy on February 02, 2020, 07:44:00 PM

it doesn't even matter which matter doesn't matter, as stated, make sure your key is right is the only important matter.