xboxscene.org forums
OG Xbox Forums => Modchip Forums => TSOP flashing => Topic started by: ClintiePoo on May 31, 2006, 08:49:00 PM
-
I have a 1.0 xbox. When I bought it it had a homebrew chip in it and also had the TSOP flashed. I took out the homebrew chip, put in an X3, and flashed the TSOP back to the MS bios. Now, months later, the xbox doesn't work when I try to boot without the chip. It shuts off immediately, and boots to the X3. Should I try to re-flash the TSOP? Is there something inside that could short and cause this (I have been doing some circuitry inside)? I'm not sure where to go with this.
-
its probably a normal 2x reboot and FRAG, but with the way the x3 enables it kicks in on the reboot (i had the same thing happen with aladdins)
anyway, since its a 1.0 you can try the 3 wire trick, or try to boot each bank inidvidually, if you cna get it to boot remove the wires and flash the TSOP with the retail bios again