xboxscene.org forums

Xbox360 Forums => Xbox360 Hardware Forums => Xbox360 General / Hardware Chat => Topic started by: yodacallmesome on December 15, 2007, 07:52:00 AM

Title: How To Disable All Wireless Activity? (radio Silent)
Post by: yodacallmesome on December 15, 2007, 07:52:00 AM
I happen to live very close to a radio telescope, and therefore cannot use wireless, microwave ovens,
cell phones and the like.

Is there a way to use *only wired* controllers?

Cheers,
-- yodacallmesome

PS: Just in case you are wondering about radio telescopes and what they look like:
http://www.gb.nrao.edu/
Title: How To Disable All Wireless Activity? (radio Silent)
Post by: Allegro1 on December 17, 2007, 10:27:00 AM
QUOTE(yodacallmesome @ Dec 15 2007, 06:52 AM) View Post

I happen to live very close to a radio telescope, and therefore cannot use wireless, microwave ovens,
cell phones and the like.

Is there a way to use *only wired* controllers?

Cheers,
-- yodacallmesome

PS: Just in case you are wondering about radio telescopes and what they look like:
http://www.gb.nrao.edu/



Someone correct me if I am wrong, but I believe that the Xbox 1 is wireless to begin with.  

You have to plug in a wireless network adapter or a wireless controller dongle to make it intentionally transmit wireless RF.  If you are talking about the Xbox360, it has built in wireless for its controllers, but not the original Xbox.  If you open the Xbox 1 up, you'll see quite a bit of RF shielding for FCC compliance so it should be safe around the radio telescopes so long as you are not right next to the receivers.  Make sure you use the official power cord with the ferrite beads built in so you won't be radiating RF through the power cord and you should be fine.
Title: How To Disable All Wireless Activity? (radio Silent)
Post by: yodacallmesome on December 19, 2007, 09:17:00 PM
Sorry, I should have been more specific. My question was about the Xbox-360.
So if I understand, as long as I have a wired controller plugged in, I need not worry about
the box transmitting? (Perhaps I should ask our RFI group test one!)
Title: How To Disable All Wireless Activity? (radio Silent)
Post by: StrictPuppet on December 19, 2007, 09:24:00 PM
You may find this interesting... http://www.networkwo...eless-lans.html

You probably have to remove the rf module from the console, as it is "on" at all times.

And moving to 360 general/hardware.....

Title: How To Disable All Wireless Activity? (radio Silent)
Post by: Symph0ny on February 03, 2020, 10:00:00 PM
The 360 works fine without the rf board installed.  You just need to take apart the case, remove 3 screws that hold it in place, and pull it out.

The only disadvantage (besides the obvious no wireless capabilities) is the lack of a power button.  You can of course use the guide button on your wired controllers instead.
Title: How To Disable All Wireless Activity? (radio Silent)
Post by: Symph0ny on December 21, 2007, 04:42:00 PM
Unfortunately it will.  The RF module is outside the main steel shield, but inside the plastic casing.  The warranty seal is on the plastic casing, just behind the faceplate, and you can't open the case without breaking it.