Post by: Dopeyman on February 11, 2012, 02:55:00 PM
QUOTE(wingrg @ Feb 11 2012, 11:35 AM) 
Hi to all, i'm a little confuse about If its necessary or not to use the AP25 process on XBC 350, its take so long to finish the measurement process. As i understand you can uncheck the AP25 process in options and when finish pass or run the ISO on ABGX 1.06 to inject Topology and AP25 measurements, I only need someone with experience to verify if im correct or not.
TX.
You're correct... You can uncheck the process and let abgx take care of the rest...
Post by: wingrg on February 11, 2012, 07:07:00 PM