Post by: dordor20 on June 10, 2007, 10:43:00 AM
I flashed an MS25 (in a new unmodified xbox) with Iprep and 1.2 ,
i spoofed the firmware as MS25 (as this was the original drive version)
then flashed it without any problems, all as usual.
i ran the xbox, booted up some backups like forza and call of juarez
they booted just fine but froze a couple of seconds or minutes after starting.
just random freezes,
without panicking, i went back to flashing and used the old Ixtreme 1.00 to hack the orig.bin i dumped from the drive.
(wasn't spoofed as i did it with the ixtreme hackfirmware process)
flashed it again, now everything is just perfect . all the same discs run flawlessly
did anyone encounter anything like that?
are there some new bugs on the Ixtreme 1.2 ?
Post by: bastard_dog on June 13, 2007, 03:30:00 AM
Post by: SimianEtza on June 13, 2007, 06:54:00 AM
Post by: r11tbo on June 13, 2007, 12:12:00 PM
Post by: zenkiS14 on June 13, 2007, 12:54:00 PM
Post by: mat82284 on June 13, 2007, 08:18:00 PM
Post by: zenkiS14 on June 13, 2007, 08:38:00 PM
I followed THIS Guide to extract and flash the bin. But I used the command prompt thats included with the ixtreme 1.2 to create the 1.2 bin with my key. It originally came with a MS28, but I swapped it out with a MS25 and used no spoofing
Post by: tot31 on June 13, 2007, 10:19:00 PM
QUOTE(zenkiS14 @ Jun 14 2007, 10:38 AM) 
I started to play forza and ran into similar problems. Not freezing though. What would happen is I would be playing and the course would not be rendered or would show up black. Its the only game I've played so far and I only seen this happening after going to 1.2.
I had the same problem as yours where one of the track wouldn't rendered properly, just showed up black. I'm on ixtreme 1.0. After I run FM2 update, everything is fine now. So I think you better do the game update. ixtreme 1.2 is ok.
Post by: Havok on June 13, 2007, 10:54:00 PM
Post by: sosotiit on June 14, 2007, 07:00:00 AM
Software?
drive?
FW?
media?
and have you verified the image against the file ripped with imgburn ( How to verify a burn )
I know one person that did his backup of forza and he says he has no prob at all with 1.2.
moved to backup for now
-soso
Post by: mcatrage on June 14, 2007, 10:49:00 AM
Post by: Jaymioz on June 14, 2007, 06:27:00 PM
This post has been edited by Jaymioz: Jun 15 2007, 01:28 AM
Post by: sosotiit on June 14, 2007, 06:44:00 PM
burn at what speed
have you done a verify of the burn against image?
-soso
Post by: toliman on June 15, 2007, 01:48:00 AM
my theory is the slow loading speed in the xtreme 4/5 series helped out on game content loading from backup media. especially memorable on games like dead rising, which sometimes flubs entire textures so you see odd things like clipped hands wandering towards you.
is it likely to be that fast/slow aspect which is detectable, or is this a general safety measure in the iXtreme "playing it safe" series
This post has been edited by toliman: Jun 15 2007, 08:54 AM
Post by: Jaymioz on June 15, 2007, 11:09:00 AM
Though it was an untouched drive, I used iprep to with ixtreme 1.2 to update it using iDump, it created a HACKED.BIN and ORIG.BIN in the backups folder. ORIG.BIN is reported as being MS25 which is correct and gives a valid key, is there a possiblity that idump has had a problem when reading the firmware? Is there anything else that it needs from the firmware (that could have possibly got corrupt) or is it just the key it needs?
If all else fails, I could just swap it again with another mates, as they have no problem doing so, and I'll test it. Though I think next time I'll just use good old manual MTKFLASH.