xboxscene.org forums

Xbox360 Forums => Xbox360 Hardware Forums => Xbox360 Audio/Video Technical => Topic started by: Mick Garvey on December 27, 2005, 10:42:00 PM

Title: Standard Definiton Phillips Tv Using Component Inputs
Post by: Mick Garvey on December 27, 2005, 10:42:00 PM

Hey everyone I have recently bought a component cable for the 360 and have been struggling to get it to work on my Phillips TV for a long time. I make sure my settings are on 4:3 and it is on the lowest res befor I try to use the component cables on my phillips TV. Im getting the same effect you get when you try to use HD settings on a standard definition TV, lines flashing and weird colors. This shouldnt happen though because I turned the settings down, right?

Title: Standard Definiton Phillips Tv Using Component Inputs
Post by: Mick Garvey on December 28, 2005, 12:28:00 AM

Switch? where is the switch located? I have a Madcatz cable and it doesnt look like there is a switch on it, ill check again though.

here is a link to the one I have

Madcatz component cable

Title: Standard Definiton Phillips Tv Using Component Inputs
Post by: Mick Garvey on December 28, 2005, 12:26:00 PM

sadly I think thats the case. I guess Ill have to just wait till I can afford a new TV then and keep using my computer monitor... Definantly not going to play on composite, that for sure.