xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Technical Onboard Bios / Kernel / Dashboard Forum => Topic started by: Dicko316 on September 13, 2012, 04:12:00 AM

Title: Falcon 5771 & Spi_usb Flasher
Post by: Dicko316 on September 13, 2012, 04:12:00 AM

I think your confused mate, you cannot JTAG a falcon with a CB of 5771.

You can however Reset Glitch Hack (RGH) it.

You will however need a Glitch chip, and a way of programming it.

No diodes necessary at ALL.

Title: Falcon 5771 & Spi_usb Flasher
Post by: Dicko316 on September 13, 2012, 11:06:00 AM

Hi mate, RGH1 is what you need, you can use your SPI flasher you have now, but I dont think you will be able to program the chip with that spi flasher.

So you would either have to make a programmer cable, buy one, buy a pre programmed chip, or buy another SPI flasher.

I only use the TX products, so Coolrunner Rev C or the new CR3 Lite is what I'd reccomend. There is no need to get a CR3 either as it offers nothing more to you, even a Rev A ot Rev B of the coolrunner will work for you too so maybe have a look on ebay.

But there are alternatives, Matrix Glitcher, Squirt 360, X360 gltich chip, probably more but can't remember them lol.

I'd recommend a Coolrunner rev C and a jrunner programmer (coolrunner cable comes with this). Souldn't cost over £30/$50/45 Euros delivered.

Where are you located?

Title: Falcon 5771 & Spi_usb Flasher
Post by: Dicko316 on September 13, 2012, 01:13:00 PM

It will not be able to program the CR3 Lite.

Your SPI flasher is ok to dump and write to the nand but thats all.

Title: Falcon 5771 & Spi_usb Flasher
Post by: splify on September 13, 2012, 05:27:00 PM

**Ordering**

Thanks and Shanna tova.