Post by: blackg1000 on March 03, 2009, 05:36:00 AM
Hi,
I have recently done a BENQ to 1.41 and Liteon to 1.5, how do I go about updating them to 1.6?
I used Iprep 101 and booted from a usb pen and used MTK vendor to do the BENQ and I used Jungleflash to read the Liteon but DOSFLASH to erase and write the firmware.
I found DOSFLASH pretty straight forward to use so correct me if I am wrong but could I just use DOSFLASH on both drives and erase then write the new 1.6 firmware?
I still have the original keys for the Liteon but I don't have them for the BENQ.
I've never done an update before so any tips would be greatly appreciated.
Many Thanks,
Post by: ToBbErT on March 03, 2009, 05:39:00 AM
Post by: blackg1000 on March 03, 2009, 05:48:00 AM
I'll wait nearer the time until 1.6 is actually released and see where I go from there.
At least now that I have two firmware types I can see if any of them will fail when the new security is in full swing.
Cheers,
Post by: ToBbErT on March 03, 2009, 05:40:00 AM
Post by: Proppo on March 03, 2009, 11:25:00 AM
Post by: No ApOloGi3s on March 06, 2009, 02:30:00 AM
QUOTE(blackg1000 @ Mar 3 2009, 01:48 PM) 
It was because the BENQ is used offline and it's dead easy using Iprep instead of the CK3 I used for the Liteon.
I'll wait nearer the time until 1.6 is actually released and see where I go from there.
At least now that I have two firmware types I can see if any of them will fail when the new security is in full swing.
Cheers,
What i dont get is how i can flash a Lite-on
ive read a lot but dont seems to get it :S
can i flash the Lite-on with out the CK3 ?
and only use a program ?
i cant seem to find out how to flash it without The probe CK3
Maybe some one can help me with a little explaition on what i need ?
i can flas al other types of drives !
Post by: ToBbErT on March 11, 2009, 05:21:00 AM