Post by: jhch50 on February 12, 2009, 10:17:00 PM
Post by: Takashi on February 12, 2009, 10:23:00 PM
Iprep is a frontend for these apps after all.
c:\Dosflash
enter the number of the drive.
W for write.
type the name of the file, BENQ-OFW.bin
| Done |
This post has been edited by Takashi: Feb 13 2009, 06:31 AM
Post by: jhch50 on February 13, 2009, 12:19:00 AM
1)before i use iprep to make flash drive(choose ixtreme customer firmware, then click on "prepare destination" to make the flash drive), then boot into dos, then type
2) dBen 1234567 12345 follow the steps then
3) fBen 1234567 12345 etc. etc.
right now i assume when i make the flash drive with iprep i choose BENQ-OFW.bin instead of the ixtreme fireware when i load the firmware right? or are there more things i need to do.
Post by: Takashi on February 13, 2009, 01:51:00 PM
see here - http://forums.xbox-scene.com/index.php?showtopic=593599
You obviously didn't follow anything i said :/
Post by: GameTech on February 13, 2009, 02:30:00 PM
QUOTE(jhch50 @ Feb 13 2009, 02:55 AM) 
wait, i don't get it. i use the iprep program to make the bootable flash drive and i follow the textbook2008 guide to type in some commands in dos mode to flash my benq drive, so that's as far as i know what to do. can you explain it in more detail please.
1)before i use iprep to make flash drive(choose ixtreme customer firmware, then click on "prepare destination" to make the flash drive), then boot into dos, then type
2) dBen 1234567 12345 follow the steps then
3) fBen 1234567 12345 etc. etc.
right now i assume when i make the flash drive with iprep i choose BENQ-OFW.bin instead of the ixtreme fireware when i load the firmware right? or are there more things i need to do.
Sounds like you may have used the older version of iprep because the newer version does not use the "-" with the file name. So to restore to original firmware you would use the rben 1234567 12345
That will flash the benq back to original.
Post by: cdsmith12 on December 21, 2009, 09:12:00 PM
QUOTE(Takashi @ Feb 13 2009, 06:23 AM) 
Put BENQ-OFW.bin in the same dir as Dosflash.exe, and use that instead.
Iprep is a frontend for these apps after all.
c:\Dosflash
enter the number of the drive.
W for write.
type the name of the file, BENQ-OFW.bin
| Done |
Thanks for the info, but will this work on a Samsung MS-28, I have an unmodded bad drive and board but I read the drivekey before it went out, so I need to flash a new drive and board
Post by: sonic2120 on December 21, 2009, 09:25:00 PM
QUOTE(jhch50 @ Feb 12 2009, 11:17 PM)
Hi, I used iprep to flash my benq drive. I am sending it to microsoft for repair.
I'm surprised people have attempted to help you out with your issue after you stated your intent of fraud.
Post by: Takashi on December 21, 2009, 09:27:00 PM