xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Technical DVD-ROM and Modified DVD Firmware Forum => Topic started by: BigSteel on December 29, 2007, 11:11:00 PM

Title: Help With Iprep
Post by: BigSteel on December 29, 2007, 11:11:00 PM

I damaged the master port on my VIA6421 card.  I can use the secondary port if I manually use dosflash.  However, I would like to use iPrep instead.  When I setup my USB drive it automatically uses the master port (9800 in my case).  I need a way to change that to 9400.  Is there any way to do this?

Title: Help With Iprep
Post by: podger on December 30, 2007, 07:22:00 AM

Hitachi's are not flashed using mtkflash, they are flashed from the iPrep GUI using the drive letter as a reference.

Title: Help With Iprep
Post by: milamber on December 30, 2007, 08:16:00 AM

QUOTE(podger @ Dec 31 2007, 12:22 AM)

Hitachi's are not flashed using mtkflash, they are flashed from the iPrep GUI using the drive letter as a reference.

I think you might mean Firmware Toolbox as iPrep has nothing to do with flashing a Hitachi drive.

This post has been edited by milamber: Dec 30 2007, 04:18 PM

Title: Help With Iprep
Post by: BigSteel on December 30, 2007, 10:56:00 AM

QUOTE(milamber @ Dec 30 2007, 08:16 AM)

I think you might mean Firmware Toolbox as iPrep has nothing to do with flashing a Hitachi drive.

I am aware of that.  I am just wondering if Firmware Toolbox will pick up on the drive being connected to port 2 of the card.