Post by: T.G.McCoy on October 26, 2006, 04:34:00 PM
Post by: Mana on October 26, 2006, 06:52:00 PM
o wait that wont work cos mtkflash will try to flash as soon as u turn on the xbox360...
bugger (IMG:style_emoticons/default/smile.gif)
i guess u dont need the 0800 disc if u can do the badflash method with the via cards? only way i can see upgrading from a 4.x to a 4.x if u have a ms28 drive?
This post has been edited by Mana: Oct 27 2006, 01:53 AM
Post by: Textbook on October 26, 2006, 08:25:00 PM
QUOTE(Mana @ Oct 26 2006, 08:52 PM) 
i guess u dont need the 0800 disc if u can do the badflash method with the via cards? only way i can see upgrading from a 4.x to a 4.x if u have a ms28 drive?
Correct. Since the FirmGuard is essentially just the MS28 firmware, you can read/write to the drive using the bad flash method with a VIA chipset just like if it was a stock MS28 drive. Still probably a good idea to use the 0800 disc though.
Post by: T.G.McCoy on October 28, 2006, 10:19:00 AM
So to be sure, using the "bad flash recovery" method will work without the 0800 disc? Because if you needed the 0800 disc, i figure you would HAVE to have the vcc method on the drive because after you unlock the drive with the 0800 disc and start the bad flash recovery you have to turn the dvdrom power off and restart 15sec later. By that point the drive would have rebooted and still need the 0800 disc?
So just to be sure... the bad flash recovery works with xtreme 4.x without the 0800 disc?
Thanks
Post by: Sir Smoke XIII on October 28, 2006, 10:32:00 AM
No probs at all
Post by: T.G.McCoy on October 28, 2006, 10:46:00 AM
BTW, did you use the xb connectivity kit? or the old fashioned way. I had to replace my dvdrom using the xb connectivity kit and got a e65 error and had no idea how it happened.
Post by: Chaval BR on October 28, 2006, 07:07:00 PM
After flashing with 4.2b, I could extract the image again using the "bad flash recovery" method, it doesn't need a 0800 disc.
Thanks very much Textook, the videos and tutorials on 360mods.net help a lot!!!
My setup:
Samsumg MS28, Jul/20
Via 6421 also recommended on this forum, U$10 on newegg
Post by: ash1471 on October 28, 2006, 07:19:00 PM
QUOTE(T.G.McCoy @ Oct 27 2006, 12:34 AM)
Flashing 4.0a to 4.2a with "bad flash" method possible? After you run the 0800 image you have to turn off drive, so this won't work I figure. Is there a work around to this? Or is the only way to solder the 2 points on the dvdrom logic board.
No 0800 disc needed just flash as if u would an ms28 done many times. The VIA VT6421 Card is also needed for this unless u have a compatible via onboard sata chipset.
Post by: Mana on October 29, 2006, 10:10:00 AM
sweet (IMG:style_emoticons/default/smile.gif)