Post by: Christophercolumbus on June 06, 2006, 04:09:00 AM
If this is a yes, then i have finally think i have found the problem with making my coasters.
Chris.
Post by: chipD on June 06, 2006, 04:20:00 AM
QUOTE(Christophercolumbus @ Jun 6 2006, 10:40 AM) 
This may be a stupid question, but do i have to flash my dvd key in this file as i did with xtreme.bin?
If this is a yes, then i have finally think i have found the problem with making my coasters.
Chris.
Sorry to takes your hopes away but the answer is NO.I wondered that same question,but i went ahead and flashed xtrm0800.bin as is and my first burn was perfect.
You might be missing 1 step as its not listed in a few of the tuts floating around.
After you send the 4 12 byte lines of code via dvdinfo pro and save your ss.bin, you need to open/close the 360 dvd tray and run dvdinfo pro again and send FF 08 01 01 and just close dvdinfo pro.Then extract the image via isobuster,then isobuilder and your ready to burn via clonecd.
Post by: Christophercolumbus on June 06, 2006, 04:29:00 AM
I'll give it another go, Im not sure anymore if i have tried it that exact way because ive done it so many times & many different methods...But i'll give it another go..
Thanks
Chris.
Post by: chipD on June 06, 2006, 04:35:00 AM
QUOTE(Christophercolumbus @ Jun 6 2006, 11:00 AM)
Thanks for the help ChipD,
I'll give it another go, Im not sure anymore if i have tried it that exact way because ive done it so many times & many different methods...But i'll give it another go..
Thanks
Chris.
Well i can assure you that this has worked everytime for me.Not a single coaster yet.
Post by: jtom617 on June 06, 2006, 10:44:00 PM