Print Page - Oh Noes! E79 Falcon!

Xbox360 Forums => Xbox 360 Hacking Forums => Software Exploits Development / Research => Topic started by: wheresaldo on December 13, 2010, 01:23:00 PM

Title: Oh Noes! E79 Falcon!
Post by: wheresaldo on December 13, 2010, 01:23:00 PM

I have read many posts but still looking for a solution

Whenever I flash xell.bin (or even xbr.bin), using nandpro20b I get e79. But I can easily re flash to orig.bin and no e79

I have a falcon mobo:
Cb 5770,
7371 dash.

I have 3 good nand dumps, no bad blocks

I can read and write ok as I can get my orig.bin flashed back on and booted up w/out e79 so lpt wiring must be correct. I have double checked my jtag wires and diodes several times.

I have inserted kv and config into .bin files

Im lost please help

is it true that even without jtag jumper and diodes xell should install? I have wires installed but trying to troubleshoot.....

Title: Oh Noes! E79 Falcon!
Post by: thesonandheir on December 13, 2010, 04:32:00 PM

QUOTE(wheresaldo @ Dec 13 2010, 08:23 PM)

Your JTAG wiring is definitely wrong.

Redo it wire by wire and try again.

Title: Oh Noes! E79 Falcon!
Post by: wheresaldo on December 13, 2010, 04:47:00 PM

I have redone them unsuccessfully. going to try the faster bat41 diodes but I can't locate them. Was hoping radio shack had an alternative.....

looks like xell can be flashed and ran without the bridge and diode jtag. I can't even get that far yet

Title: Oh Noes! E79 Falcon!
Post by: wheresaldo on December 13, 2010, 07:16:00 PM

does the j1d2.4 lpt wire need a diode? i see some tut's say yes, some say no

Title: Oh Noes! E79 Falcon!
Post by: Wompa164 on January 30, 2011, 08:48:00 PM

Can you post pictures of your work?

Title: Oh Noes! E79 Falcon!
Post by: ravendrow on February 06, 2011, 06:30:00 PM

if you are absolutely positive your wiring is correct i recommend you check to see if you accidentally desoldered the r2e2 resistor when you were putting the wiring in place that will cause e79 everytime you can fix it by soldering a 1.5 k resistor back in place

Title: Oh Noes! E79 Falcon!
Post by: hangover on February 07, 2011, 08:41:00 PM

Change to the aud_clamp wiring and then use a patched smc.bin to suit.

xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Software Exploits Development / Research => Topic started by: wheresaldo on December 13, 2010, 01:23:00 PM