xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Modchip Development / Research => Topic started by: aritzilla on July 18, 2010, 02:37:00 PM

Title: Maximus Nandflasher: Could Not Detect Flash Controller
Post by: aritzilla on July 18, 2010, 02:37:00 PM

Hi,


I have bought a 360 Nand Flasher in a shop and they have installed it and XBR in my Jasper 256 MB.


XBR works fine but when I plug Nand Flasher to a PC, it doesn´t work.


The Nand flasher has the green light on and the PC detects it, but when I use Nandpro (or Hack 360) and I try to do a Nand backup, it gives me an error "Could not detect a flash controller" and I can do nothing.

The console is plugged but is turn off.

I have tested another chip with another Xbox Jasper 16 MB and it works perfectly with my PC, because of it i think i don´t have any problems with the drivers.

I resent the Xbox to the shop and the tecnician told me that works perfectly.

My Pc Bios config:

Onboard FDD Controller On
Onboard Serial Port 1 3F8/IRQ4
Onboard Parallel Port 378/IRQ7
Parallel Port Mode SPP

Onchip USB Controller Enabled
- USB COntroller Enabled
USB Emulation OFF
- USB Keyboard Support OS
- USB Mouse Support OS

What can I do? What can be my problem?

Title: Maximus Nandflasher: Could Not Detect Flash Controller
Post by: letsmod on July 22, 2010, 10:35:00 PM

your installation is not proper, most likely a solder joint is not fully connected pin 5 on J1D2 requires allot of heat since it is has a huge ground plane