xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Modchip Development / Research => Topic started by: cregmac on May 20, 2010, 03:39:00 AM

Title: Cygnos V2 Rev F Installation Help
Post by: cregmac on May 20, 2010, 03:39:00 AM

Greetings, I have a CYGNOS V2 Rev F chip to install to a JASPER MO-Board.

First thing I noticed there is no ON/OFF switch  (IMG:style_emoticons/default/sad.gif)

Second Do I need to solder the GND also? In the video that was not done.


I went ahead and soldered the chip to the MO-Board and all the quick solder points but no BLU LED comes on
 (IMG:style_emoticons/default/mad.gif)


Any assistance will be greatly appreciated  (IMG:style_emoticons/default/happy.gif)
 
I can provide photos or whatever other information needed.
Thanks


*Edit: I checked the solder points and added my own switch. Now the chip works.
Running parallels desktop on a mac virtual windows recognizes the CYGNOS chip.



New problem (IMG:style_emoticons/default/uhh.gif)  toolbox wont run  (IMG:style_emoticons/default/huh.gif)

This post has been edited by cregmac: May 20 2010, 11:19 AM

Title: Cygnos V2 Rev F Installation Help
Post by: letsmod on August 14, 2010, 07:09:00 PM

rev F doesnt get a blue light and doesn't need a switch !!  so most likely you just killed it!!

look at pic at cygnos site, NO SWITCH on there