xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => Modchip Development / Research => Topic started by: TheMerk on September 09, 2006, 03:11:00 PM

Title: Installation Question On Nme360 V1.1
Post by: TheMerk on September 09, 2006, 03:11:00 PM

Use the First Diagram.
Because the top left pic is the 3 wires that have to be installed on the fron of the board and the top right picture is on the back of the board.

And the bottom left is to disable the ethernet and the one on the right is to make the led change when the nme chip is active.

I believe I am correct?!?

Title: Installation Question On Nme360 V1.1
Post by: IMI_II_IK_IE on September 09, 2006, 03:50:00 PM

So only the four wires in the top two pics are required?  Can someone please verify this as it is not noted ANYWHERE?  FOUNDMY, any ideas on this one?

Title: Installation Question On Nme360 V1.1
Post by: TheMerk on September 09, 2006, 04:39:00 PM

Well look at this way. If you look at the Hitachi version it has 2 xtra wires that are for the

(1)"Network Off Feature"
(2)"Activity LED"

So that is what they are used for.
 100% sure dude

Title: Installation Question On Nme360 V1.1
Post by: IMI_II_IK_IE on September 11, 2006, 07:08:00 PM

Thanks for info.  Already installed modchip, and am waiting fro samsung drive and media to come in!  Hopefully I didn't mess anything up.  Good news is that it still reads originals.

Title: Installation Question On Nme360 V1.1
Post by: TheMerk on September 12, 2006, 07:14:00 PM

Yeah thats good ya didnt mess anything up. I am still waiting on my chip which should be here tomorrow.
Hitachi 47
NME-360 1.1

I have all the software and my friend has the dl drive...I need to get one