Post by: kerppo on November 22, 2012, 07:16:00 PM
QUOTE(kerppo @ Nov 23 2012, 03:24 AM) 
Hi,
So my problem is that I'm trying to glitch this falcon using rgh1 and got everything to the point where I'm suppose to boot to xell, but when i boot the console it never glitches, coolrunners green ligt keeps flashing every 5 seconds or so but it never boots to xell. I left it for about 30min and it never glitched.
I have heard that falcons can be difficult, is this true? if so, Is there any tips on how to finally get it glitch?
I have used both cpu_rst points, below the motherboard and on top, but i haven't used the 50ohm double shielded cable though, just the normal little one that came with the coolrunner wires. Could changing the wire solve my problem?
Thanks for all your help/tips. really appreciate any help!
OK update, i tried the double shielded cable but still is not glitching.
Post by: bagofcrap24 on February 03, 2013, 11:40:00 AM
QUOTE(kerppo @ Nov 23 2012, 02:16 AM)
OK update, i tried the double shielded cable but still is not glitching.
I would double and triple check your solder points.
The Falcon is the most reliable board to glitch in my honest opinion
i completely destroyed a resistor pad and broke 2x other resistors.
badly bodged it together with jump wires and bridged the missing resistors
and it has run perfectly for over a year now
always glitches first time. <5seconds from power button to boot
Post by: deilzfcjk on February 03, 2013, 10:50:00 PM