xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => General Technical Hacking Discussion => Topic started by: Sheriff on December 29, 2010, 09:46:00 PM

Title: Jtag Stoped To Works....
Post by: Sheriff on December 29, 2010, 09:46:00 PM
QUOTE(Racquel @ Dec 29 2010, 05:49 PM) View Post

Hi,

My falcon was working pefectly with Jtag for while. I recenly updated to new kinect hack and even played halo reach (install then nxe2god). But then suddently i got E79!

What should I look at first? Does using transistor will help? My setup is acutally of 2 diods and 1 resistor.

thanks

Rac.


I had the same problems with the same wiring you had...Once I did the transistor method I have never seen a E79 for a long time.
Title: Jtag Stoped To Works....
Post by: Racquel on December 31, 2010, 04:19:00 PM
So far I failed to have it reboot with diod, i have redone all soldering and change diods still E79.


However i had a permanent plug for LPT and i am able to read the nand again.


However when i compare the nand read with the last one i flashed(12611 borad) theres 22 blocks that are different!

Is this normal, could it be a an error or a path from microsoft?


My next step is put back original nand and test it to see.

thanks!!
Title: Jtag Stoped To Works....
Post by: hellracer on January 01, 2011, 08:02:00 AM
I have put back orig.bin and console works.



Should i flash first with aud_clamp fix for EFB then solder transisistors or ding trans first?

tks
Title: Jtag Stoped To Works....
Post by: shawndezy115 on January 01, 2011, 12:26:00 PM
since you have a permanent plug you can do either or.
just flash with aud_clamp then do wiring.

you dint boot up when you had your wiring redone because of the SMC wasn't changed.
the black addrs tool changes the jtag point so the wireing has to match.

good luck let us know how it goes.
Title: Jtag Stoped To Works....
Post by: Racquel on January 01, 2011, 09:11:00 PM
installed the transistors,

followed ur instruction for the SMC, flashed and it works!

however the freeboot i have is not kinect compatible. I need another update , what should i do?




thanks