xboxscene.org forums

Xbox360 Forums => Xbox 360 Hacking Forums => General Technical Hacking Discussion => Topic started by: swampy1111 on December 12, 2007, 09:36:00 PM

Title: Using Willem Programmer
Post by: swampy1111 on December 12, 2007, 09:36:00 PM

can someone please just nudge me in the right  direction
ive got a couple of willem programmers and ive just bought the add-on to read the 79fl chips
do i use the software that came with the willem or something like icprog
i'm going to read the eeproms and use ms 28s (ive got no probs with doing that) but my progrmming knowledge is a tad limited

    thanx
       swampy

Title: Using Willem Programmer
Post by: Perplexer on February 02, 2020, 09:49:00 PM

Use the software which came with the Willem.  It will allow you to select the proper flash type for the SST 39LF020 and also display which DIP switches you need to set on your programmer.

Read the chip and bring up the dump in Firmware Toolbox to make sure it dumped properly.

Title: Using Willem Programmer
Post by: swampy1111 on December 20, 2007, 08:49:00 PM

had my new samsung drive today
put the eeprom into the programmer but i cant see the option for SST 39LF020 i can see one for 29lf/fv020
and one for 39lf/fv040
so what software do i need i got all the willem stuff i could find but no luck
my programmer is a willem pcb45