xboxscene.org forums

OG Xbox Forums => Software Forums => Xbox Homebrew Software => Topic started by: derf on January 05, 2003, 05:49:00 PM

Title: Quake 2x
Post by: derf on January 05, 2003, 05:49:00 PM

Just like to say I installed Quake2X v3 last night and I was very surprised on the quality of the port, well done to the guys who ported it. That’s just in case any of them visit this board. I highly recommend it, if you didn’t play it to death on the PC of course.

Title: Quake 2x
Post by: mr jones on January 07, 2003, 09:41:00 AM

I sort  of gave up on it.  I STILL can't get the game to work correctly.  I'll install the full version of the game, put everything from the installed game from my PC to the xbox, put in the xbe, and it will run....with no video.  Its like someone turns the sync on my TV off - it just goes black.

No idea how to fix it... <_<

mr jones

Title: Quake 2x
Post by: derf on January 07, 2003, 05:40:00 PM

Try changing the vid_xboxSyncMode in the config file, see below.


vid_xboxSyncMode
Sets how to sync to the vertical blank.
 
0 = No syncing, game will run as fast as possible, screen may tear
1 = Sync to vblank, locks game to 50 (PAL50) or 60 fps (PAL60 & NTSC)
2 = Sync to every second vblank, locks game to 25 (PAL50) or 30 fps (PAL60 & NTSC)

Title: Quake 2x
Post by: derf on January 07, 2003, 05:42:00 PM

Sorry or the gl_mode

Sets the screen resolution to use.
Not a new command, but i've changed which modes are available.
These modes are available:
     
   Mode 0: 640x480   (480p)
   Mode 1: 640x576   (only for PAL50)
   Mode 2: 720x480
   Mode 3: 720x576   (only for PAL50)
   Mode 4: 1280x720  (720p)
   Mode 5: 1920x1080 (1080i)